5 (86) · € 207.00 · En stock
Hi there I’m haveing a problem with my laser machine which is sculpfun s9 The problem is that the machine doesn’t complete any work at all and it stop working in the middle It starts like for less than minute then stop in some point and don’t complete until I reset it then get back to the same problem but it doesn’t stop all time in same place I am using lightburn software and i used lasergrbl and both has the same issue It stop as in this photo and the laser still burning
Sculpfun S9 Laser Engraver Problem
Sculpfun S9 diagnostic, X Axis Judder.
SculpFun S9 Laser Build and 1st Time Testing
SCULPFUN S9: New User Troubleshooting Guide – GearBerry
SCULPFUN S30 Pro Laser Module – sculpfun
Sculpfun s9 laser machine - GRBL - V1 Engineering Forum
Sculpfun S9 laser - Solid State Lasers - Maker Forums
Connecting MKS DLC32 to Neje laser, common power supply - Troubleshooting - V1 Engineering Forum
Sculpfun S9 laser dot and accuracy mediocre while Genmitsu nearly perfect - Sculpfun - LightBurn Software Forum
Review of the Sculpfun S9 5.5W Diode Laser, with tips and tricks!