ATmega328P CH340 USB Microcontroller Board Arduino Compatible – Envistia Mall
4.9 (509) · € 5.00 · En stock
This Arduino-Compatible ATmega328P development board has all of the features of the original Arduino Uno with the added benefit of an ISP header and CH340G USB interface. The UNO can be programmed over a USB B cable using the Arduino IDE.
Arduino Board
Treedix 2pcs ATmega328P CH340 Development Board Compatible with Arduin – Treedix Official
HiLetgo 3pcs Nano 3.0 ATmega328P Type-C USB CH340 Controller Board Compatible to
ELEGOO EL-CB-001 Uno R3 Board ATmega328P ATmega16U2 with USB Cable for Arduino
Description Please note this is not official/original Arduino UNO R3, it comes with CH340G Serial/USB chip. Package Includes: 1 x Arduino UNO
Generic ATmega328P CH340 Compatible with Arduino UNO R3 w/ USB Cable
ATmega328P USB-C CH340 Microcontroller Development Board Arduino Compa – Envistia Mall
This Arduino-Compatible ATmega328P development board has all of the features of the original Arduino Uno with the added benefit of an ISP header and CH340G USB interface. This development board can be programmed over a USB B cable using the Arduino IDE: Just plug in the board, select Arduino UNO from the board menu and you are ready to upload sketches. You can power the Board over USB or through the barrel jack.
Arduino Uno R3 Compatible ATmega328P CH340 USB Microcontroller Board
WWZMDiB UNO R3 ATmega328P microcontroller CH340G Improved Version Development Board Compatible with Arduino IDE with USB Cable and 2.54mm Straight Pin Header : Electronics
Attention:before running the procedure, pls install the corresponding computer system driver. Drivers: directly from the chip manufacturer: WCH 340
Mini Nano V3.0 ATmega328P Module Micro Controller Board with USB Cable for Arduino
ATmega328P Board 16MHz CH340G Cable (Arduino-Compatible) – Flux Workshop
Mini Nano V3.0 ATmega328P Module Micro Controller Board with USB Cable for Arduino : Electronics
The Arduino-compatible Nano V3.0 micro-controller is a small, complete, micro-controller board based on the ATmega328P MCU. It has more or less the same functionality of the Arduino Duemilanove, but in a smaller package. It lacks only a DC power jack, and uses a more compact Mini USB (Mini-B) USB cable instead of a standard one. The Nano IO Expansion Shield is designed to connect and work with ARDUINO Compatible NANO Micro-Controllers.
Nano 3.0 Micro-Controller ATmega328P with I / O Expansion Shield Module
The Pro Micro is similar to the Pro Mini except it uses an ATmega32U4 rather than an ATmega328 microcontroller on board. The USB transceiver inside the 32U4 incorporates USB connectivity on-board and does away with a bulky external USB interface. This tiny micro-controller board does all of the Arduino tricks that you're familiar with: 4 channels of 10-bit ADC, 5 PWM pins, 12 DIOs as well as hardware serial connections for Rx and Tx.
Pro Micro ATmega32U4 5V 16MHz Leonardo replaces ATmega328 Pro Mini Arduino
This Arduino-compatible Nano V3.0 micro-controller is a small, complete, micro-controller board based on the ATmega328 MCU. It has more or less the same functionality of the Arduino Duemilanove, but in a smaller package. It lacks only a DC power jack, and uses the more compact Mini USB (Mini-B) connector instead of a standard USB connector. It is compatible with Arduino programs and the Arduino IDE. This version of the Nano uses the CH340G USB interface controller.
Nano V3.0 ATmega328 CH340G 5V 16M Micro-Controller with Mini USB Cable
